What Chemical and Dosing Data Does Dosing Pump Selection Need?

Aerial view of a wastewater plant with clarifiers, bubbling aeration tanks and blue FRP dosing tanks

A dosing pump should be selected for the actual dosing range and injection conditions. Choosing the largest catalogue capacity can leave normal operation poorly suited to the control requirements.

Use Consistent Dosing Units

State the chemical, concentration, temperature and the minimum, normal and maximum solution flow. If the process requirement is expressed as mass of active chemical, the process engineer should convert it to solution flow using the corresponding concentration and density. Do not mix mass and volume units without a basis.

Record the suction liquid level, pipe layout, injection pressure range and operating mode. Ask the manufacturer for capacity performance and turndown limits at the actual pressure and chemical, not just the advertised maximum flow.

Check Controls and Wetted Parts

State whether adjustment is manual or by signal, and what feedback is required. Check the compatibility of the pump head, diaphragm or seals, valves and hoses item by item, and ask how the selected model handles calibration, gas locking and pulsation. Necessary protection is determined by the designer and the manufacturer.

Submit your dosing sheet and installation sketch and KFE can coordinate equipment data. Treatment dosage is a process decision; this article does not specify chemical doses or guarantee the metering accuracy of an unspecified model.

Related industry: Water & Wastewater Treatment

Related Products

Send Us Your Equipment List or Operating Conditions

Tell us what you need. KFE handles the quote, specs and delivery, with one contact for you.

Contact KFE