For: Maintenance engineers aligning pumps and motors after installation or overhaul, to cut vibration and protect bearings and mechanical seals.
Why Alignment Matters
Common effects of misalignment:
- Coupling elements wear out early and can fail.
- Bearings run hotter and their service life drops noticeably.
- Mechanical seals leak more often.
- Vibration and noise rise; the spectrum often shows a higher 2X (twice running speed) component.
Goal: Keep offset and angularity within the limits set by the coupling and pump manufacturers. Tolerances depend on speed (the higher the speed, the tighter the limit), so no single figure fits every machine.
1. Two Types of Misalignment
1. Offset (Parallel Misalignment)
Definition: The shaft centerlines are parallel but shifted vertically or horizontally. Measured in mm.
2. Angularity (Angular Misalignment)
Definition: The shaft centerlines meet at an angle (a “gap” opens on one side). Usually given in mm/100 mm, i.e. the face gap difference per 100 mm of diameter.
Worked example: An angularity of 0.05 mm/100 mm on a 200 mm coupling face gives a top-to-bottom gap difference of 0.05 × 200 ÷ 100 = 0.10 mm.
3. Typical Reference Tolerances (Short Flexible Couplings)
The ranges below are typical guidance from laser alignment suppliers and industry references. The lower end is close to “excellent” and the upper end close to “acceptable”. Final acceptance follows the coupling and pump manufacturer’s manual and the project specification.
| Speed | Offset | Angularity |
|---|---|---|
| 1500 / 1800 rpm | approx. 0.05–0.09 mm | approx. 0.05–0.07 mm/100 mm |
| 3000 / 3600 rpm | approx. 0.03–0.06 mm | approx. 0.03–0.04 mm/100 mm |
For gear, disc and spacer couplings, and for large or high-temperature units, use the manufacturer’s tolerances.
2. Alignment Methods
Method 1: Straightedge + Feeler Gauge (Rough Alignment)
For: Initial setting of small, low-speed pumps, or rough adjustment before dial or laser alignment.
Steps:
- Lay a straightedge across both coupling hubs at top, bottom, left and right to judge offset.
- Measure the face gap with feeler gauges at 0°, 90°, 180° and 270°, convert the gap difference to mm/100 mm, and compare it with the table above.
Drawback: Limited accuracy, affected by how true the hub surfaces are. Not recommended for final acceptance.
If you are sourcing pumps, valves or related equipment for a project, send KFE your equipment list and operating data and we will help with selection and quotation.
Related industry: Chemical & Pharmaceutical




