A dosing skid must be built around a defined chemical and injection duty. A chemical name or pump capacity alone leaves the dosing range, pressure conditions and control interfaces undefined.
Prepare a process input sheet
Record the chemical identity, concentration, temperature, density or viscosity where relevant, and the minimum, normal and maximum dosing flow. Distinguish the solution flow from the active chemical dose; conversions and treatment requirements should be set by the process designer.
Describe the suction arrangement, injection pressure range, pipe length, tank location and available utilities. Include every wetted part, such as seals, hoses, valves and instruments, in the material compatibility check; a suitable pump casing does not mean the whole flow path is suitable.
Define interfaces and abnormal responses
Confirm who supplies the chemical tank, injection assembly, spill containment and control signals. The designer and manufacturer should define overpressure protection, calibration conditions and the action on low level or signal loss. Do not assume that different metering technologies handle gassing and pulsation in the same way.
Submit the input sheet and a marked-up process drawing, and KFE can coordinate the review with partner manufacturers. Dosing rates and safety measures still require project engineering approval; coordination does not replace engineering design.
Related industry: Chemical & Pharmaceutical




