Even with the same power and connection size, a replacement pump may run differently or not fit. The old installation is evidence, not a complete new requirement.
Build an Old-versus-New Comparison
Record the old and new models, actual duty, speed, impeller configuration, nozzle sizes, installed length and feet, and add media mix, temperature and suction conditions. Keep measured performance separate from design values that were never verified.
For electrical controls, compare power supply, starter or VFD compatibility, signals and communication. A new motor nameplate does not prove compatibility with the old VFD and control sequence.
Plan the Actual Replacement
Confirm service space, removal route, support and alignment requirements. Do not force existing piping onto mismatched pump nozzles. If the new curve differs, the designer should assess the system, balancing and allowable operating range.
Submit old data, site dimensions and the current problem and KFE can coordinate an evidence-based replacement comparison. Whether a direct swap is possible, and the final settings, must be confirmed against the real installation, not guaranteed from photos.
Related industry: HVAC




